No products in the cart.
Battery Charging Module, DIY Items, Electronic Parts, Trending Items
BMS Lithium Battery Charger Protection Board(7S, 29.4V)
Availability:
In stock
HXYP-TY-T20
- Over discharge voltage range: 2.5±0.05V
- Overcharge voltage range: 4.25±0.05V
- Upper limit momentary current: 20A
- Upper limit working current: 15 A
16,400 Ks
This is 7S 25.9V 29.4V 15A 18650 Lithium Battery Protection Board. The module comes with overcharge protection, over-discharge protection, short circuit, and over-current protection features.
| Model No. | HXYP-TY-T20 |
|---|
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module
DS3231 RTC Module
Out of stock- Weight: 8g
- Operating voltage :3.3 – 5 .5 V
- Clock chip: high-precision clock chip DS3231
- Clock Accuracy :0-40 ℃ range, the accuracy 2ppm, the error was about 1 minute
- Calendar alarm clock with two
- Programmable square-wave output
- Real time clock generator seconds, minutes, hours, day, date, month and year timing and provide valid until the year 2100 leap year compensation
- Chip temperature sensor comes with an accuracy of ± 3 ℃
- Memory chips: AT24C32 (storage capacity 32K)
- I2C bus interface, the maximum transmission speed of 400KHz (working voltage of 5V)
SKU: EAP-000006 - DIY Items, Electronic Parts, Module, Relay Module
8 Channel Relay Module (5V,10A)
47 in stockDC or AC signal, control, you can control the 220V AC load;
There is a normally open and one normally close contact;
The module is compliant with international safety standards, control and load areas isolation trenches.SKU: EAP-000010 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - DIY Items, Electronic Parts, Module, Relay Module
2 Channel Relay Module (5V,10A)
8 in stock- Switching mains loads
- Home automation
- Battery backup
- High current load switching
- Supply voltage – 3.75V to 6V
- Trigger current – 5mA
- Current when relay is active – ~70mA (single), ~140mA (both)
- Relay maximum contact voltage – 250VAC, 30VDC
- Relay maximum current – 10A
SKU: EAP-000012
There are no reviews yet.