No products in the cart.
Battery, Component, Electronic Parts
SONY SR626SW Cell Battery(1.55V) x (1Pcs)
Availability:
Out of stock
- Battery Voltage:Â 1.55V
- Battery Chemistry:Â Silver Oxide
- Battery Size:Â 377 SR626SW
- Battery Capacity:Â 28mAh
5,800 Ks
Out of stock
Sony SR626SW 377 28mAh 1.55V Silver Oxide Watch Battery.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - DIY Items, Electronic Parts, Module, Relay Module
4 Channel Relay Module (5V,10A)
3 in stock- Useful for appliance control
- DC or AC signal, control, you can control the 220V AC load
- There is a normally open and one normally close contact
- The module is compliant with international safety standards, control and load areas isolation trenches
SKU: EAP-000011 - Electronic Parts, Module, OLED Display Module
TM1637 Clock Display Module
46 in stock- Ease to use.
- Ease of multiplexing.
- Can use as a 4 digit display unit.
- Can use as a clock display.
- DIY clock project.
- 4 digit display unit.
- Electrical/Electronic projects.
- The counter project using 7 segment display.
- 4 M2 screws positioning holes for easy installation
SKU: EAP-000007 - DIY Items, Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
18 in stock- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013
There are no reviews yet.