No products in the cart.
Detection & Sensor Module, Electronic Parts, Module
GY-68 BMP180 Barometric Sensor Module
Availability:
In stock
- 1.8V to 3.6V Voltage
- Low power consumption – 0.5uA at 1Hz
- I2C interface
- Maximum I2C speed: 3.5Mhz
- Very low noise – up to 0.02hPa (17cm)
- Completely calibrated
- Pressure Range: 300hPa to 1100hPa (+9000m to -500m)
4,300 Ks
In stock
- Measuring the absolute pressure of the environment using a digital barometer like this one has some interesting applications. By converting the measured pressure into altitude, you have a reliable sensor to determine the height of your robot, plane.
- Using a sensor as capable as the BMP180 you can achieve 1m accuracy, with noise of just 17cm in ultra high resolution noise. The device will operate at just 0.3uA, meaning low current consumption for battery-powered applications.
- The BMP180 comes fully calibrated and ready to use. Since the device operates over I2C, we have added optional I2C pull ups that can be activated using the PU (pull up) jumper on the board for your convenience and ease during breadboarding.
- Using I2C, the device provides pressure and temperature as 16bit values, which are used together with calibration data within the device to provide a temperature compensated altitude calculation.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Detection & Sensor Module, Electronic Parts, Module
HTU21D Temperature and Humidity Sensor Module
Stock outDetection & Sensor Module, Electronic Parts, ModuleHTU21D Temperature and Humidity Sensor Module
Out of stock- ​Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 - Development Board, Electronic Parts, STM
STM32F103C8T6 ARM Development Board
8 in stock- 100% Brand new and high-quality STM32 Board
- 72MHz work frequency.
- 64K flash memory, 20K SRAM.
- 2.0-3.6V power, I/O.
- Reset(POR/PDR).
- 4-16MHz crystal.
- Onboard Mini USB interface, you can give the board power supply and USB communication.
SKU: EAP-000021 - DIY Items, Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
18 in stock- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013
There are no reviews yet.