This is FS1000A 433mHz Tx RF Radio Module. This RF module comprises an RF Transmitter and an RF Receiver. The transmitter/receiver (Tx/Rx) pair operates at a frequency of 433 MHz. An RF transmitter receives serial data and transmits it wirelessly through RF through its antenna connected at pin4. The transmission occurs at the rate of 1Kbps – 10Kbps. The transmitted data is received by an RF receiver operating at the same frequency as that of the transmitter.
Electronic Parts, Module
RF Receiver Module (433MHz)
Availability:
In stock
- Voltage: 5V (DC)
- Static current: 4mA
- Receiver Frequency: 433MHz
- Receiver sensitivity: -105dB
- External antenna: 32cm single-core wire, wound into a spiral
- Dimensions (L x W): 30 x 13mm
5,900 Ks
In stock
Based on 0 reviews
0.0 overall
0
0
0
0
0
Only logged in customers who have purchased this product may leave a review.
Related products
- DIY Items, Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
18 in stock0 out of 5(0)- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stockRated 5.00 out of 5(1)- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - Detection & Sensor Module, Electronic Parts, Module
DHT11 Temperature and Humidity Sensor Module
In StockDetection & Sensor Module, Electronic Parts, ModuleDHT11 Temperature and Humidity Sensor Module
386 in stock0 out of 5(0)- The module can detect the surrounding environment of the humidity and temperature
- High reliability and excellent long-term stability
- The output from the digital output
- Humidity measuring range: 20%~90%RH(0~50 degree (temperature compensation)
- Temperature measuring range: 0~+50degree
- Humidity measurement accuracy: ±5.0%RH
- Temperature measurement accuracy: ±2.0degree
- Power Supply: 3.3~5.5V DC
- Output: 4 pin single row
- Interchangeability: Fully Interchangeable
- Long-Term Stability: <±1%RH/year
SKU: EAP-000003







There are no reviews yet.