No products in the cart.
Component, DIY Items, Electronic Parts, Potentiometer
WH-148 Potentiometer
Availability:
In stock
WH-148 Potentiometer
- Type: B Type Taper – linear
- Material: Carbon Film + Metal
- Interface: 3PIN
- Shaft Length: About 15mm
Price range: 1,400 Ks through 1,500 Ks
WH-148 potentiometer 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
| Resistance | B100R, B500R, B1K, B5K, B10K, B20K, B100K, B1M, B50K |
|---|
Based on 1 review
Only logged in customers who have purchased this product may leave a review.
Related products
- Detection & Sensor Module, Electronic Parts, Module
HTU21D Temperature and Humidity Sensor Module
Stock outDetection & Sensor Module, Electronic Parts, ModuleHTU21D Temperature and Humidity Sensor Module
Out of stock- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32 Development Board with SIM800L V1.3
DiscontinuedStock outDevelopment Board, Electronic Parts, ESPRESSIF(ESP)ESP32 Development Board with SIM800L V1.3
Out of stock- Wi-Fi mode: Station/SoftAP/SoftAP+Station/P2P
- Security mechanism: WPA/WPA2/WPA2-Enterprise/WPS
- Encryption type: AES/RSA/ECC/SHA
- Firmware upgrade: UART download/OTA（Through network/host to download and write firmware）
- Software development: Support cloud server development /SDK for user firmware development
- Networking protocol: IPv4、IPv6、SSL、TCP/UDP/HTTP/FTP/MQTT
- User configuration: AT + Instruction set, cloud server, android/iOSapp
- OS: FreeRTOS
SKU: EAP-000023 - Electronic Parts, Module, OLED Display Module
0.91 OLED Display Module (Blue)
75 in stock- 0.91 inch I2C/IIC 128×32 OLED Display Module
- Work perfectly well without the need of back light.
- 128*32 high resolution, ultra wide viewing angle
- The display is self-illuminating
- Power requirement is low
- Fully compatible with multiple controlling chips including Arduino and more.
- Better performance characteristics than traditional LCD and LED displays.
SKU: EAP-000020 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024
There are no reviews yet.