No products in the cart.
Electronic Parts, Module, Optoelectronic & LED Module
RGB SMD LED Module
Availability:
In stock
- RGB SMD LED Module
- RGB trichromatic limiting resistor to prevent burnout
- PWM adjusted color mixing
- Working voltage: 5V
- LED drive mode: Common cathode driver
600 Ks
In stock
SMD RGB LED module consists of a full-color LED made by R, G, B three-pin PWM voltage input can be adjusted. Primary colors (red/blue/green) strength in order to achieve a full-color mixing effect. Control of the module with the Arduino can be achieved Cool lighting effects.
The RGB Full Color LED SMD Module consists of a 5050 SMD LED, use with limiting resistors to prevent burnout. Compatible with popular electronics platforms like Arduino, Raspberry Pi, and ESP8266.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module
DS3231 RTC Module
1 in stock- Weight: 8g
- Operating voltage :3.3 – 5 .5 V
- Clock chip: high-precision clock chip DS3231
- Clock Accuracy :0-40 ℃ range, the accuracy 2ppm, the error was about 1 minute
- Calendar alarm clock with two
- Programmable square-wave output
- Real time clock generator seconds, minutes, hours, day, date, month and year timing and provide valid until the year 2100 leap year compensation
- Chip temperature sensor comes with an accuracy of ± 3 ℃
- Memory chips: AT24C32 (storage capacity 32K)
- I2C bus interface, the maximum transmission speed of 400KHz (working voltage of 5V)
SKU: EAP-000006 - Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32 Development Board with 1.14 Inch LCD
In StockElectronic Parts, Development Board, ESPRESSIF(ESP)ESP32 Development Board with 1.14 Inch LCD
2 in stock- Wi-Fi Mode Station/SoftAP/SoftAP+Station/P2P
- Security mechanism WPA/WPA2/WPA2-Enterprise/WPS
- Encryption Type AES/RSA/ECC/SHA
- Firmware upgrade UART download/OTA（Through network/host to download and write firmware）
- Software Development Support cloud server development /SDK for user firmware development
- Networking protocol IPv4, IPv6, SSL, TCP/UDP/HTTP/FTP/MQTT
- User Configuration AT + Instruction set, cloud server, android/iOSapp
- OS FreeRTOS
SKU: EAP-000022 - Electronic Parts, Module, Detection & Sensor Module
Raindrop Detection Sensor Module
2 in stock- The LM393, use of the wide voltage comparator
- Provide both digital and analog output
- Output LED indicator
- Compatible with Arduino
- TTL Compatible
- The sensor uses the high-quality FR – 04 double material, the large area of 5.5*4.0 CM
- Treatment of nickel plating and surface, have fight oxidation, electrical conductivity, and life has more superior performance
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15mA
- With potentiometer sensitivity adjustment
- The output format: digital switch output (0 and 1) and analog AO voltage output;
- Has a fixed bolt hole, convenient installation
SKU: EAP-000001 - Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32-Cam Development Board
4 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024
There are no reviews yet.