No products in the cart.
Battery, Component, Electronic Parts
Ni-MH JINMASI 3500mAh 4.8V Rechargeable
Availability:
In stock
- Battery Capacity – 3500mAh
- Brand – JINMASI
- Voltage – 4.8V
- Battery Type – NI-MH
- Type – Rechargeable
154,000 Ks
In stock
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - Electronic Parts, Module, OLED Display Module
0.96 OLED Display Module (128×64) (Blue)
Out of stock- Work perfectly well without the need of back light.
- 128*64 high resolution, ultra wide viewing angle
- Super low power consumption–only 0.08W when the whole screen lights up and 0.06W when displaying characters
- Fully compatible with multiple controlling chips including Arduino and more.
- Support a wide range of voltage input
SKU: EAP-000019 - DIY Items, Electronic Parts, Module, Relay Module
8 Channel Relay Module (5V,10A)
47 in stockDC or AC signal, control, you can control the 220V AC load;
There is a normally open and one normally close contact;
The module is compliant with international safety standards, control and load areas isolation trenches.SKU: EAP-000010 - Detection & Sensor Module, Electronic Parts, Module
HTU21D Temperature and Humidity Sensor Module
Stock outDetection & Sensor Module, Electronic Parts, ModuleHTU21D Temperature and Humidity Sensor Module
Out of stock- ​Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002
There are no reviews yet.