No products in the cart.
Component, Electronic Parts
Light Dependent Resistor
Availability:
In stock
- LDR (5528)
- Light Resistance: 10 – 20KΩ
- Dark Resistance: 1MΩ
- Rise Time: 20ms
- Fall Time: 30ms
- LDR(5549)
- Light Resistance: 100 – 200KΩ
- Dark Resistance: 10MΩ
- Rise Time: 20ms
- Fall Time: 30ms
130 Ks
- This cadmium sulfide (CdS) or light dependent resistor (LDR) whose resistance is inversely dependent on the amount of light falling on it is known by many names including the photo resistor, photoresistor, photoconductor, photoconductive cell, or simply the photocell.
| Part No | GL5528, GL5549 |
|---|
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32-Cam Development Board
5 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - Electronic Parts, Module, Detection & Sensor Module
HTU21D Temperature and Humidity Sensor Module
In StockElectronic Parts, Module, Detection & Sensor ModuleHTU21D Temperature and Humidity Sensor Module
7 in stock- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 - Electronic Parts, Module, Relay Module
2 Channel Relay Module (5V,10A)
6 in stock- Switching mains loads
- Home automation
- Battery backup
- High current load switching
- Supply voltage – 3.75V to 6V
- Trigger current – 5mA
- Current when relay is active – ~70mA (single), ~140mA (both)
- Relay maximum contact voltage – 250VAC, 30VDC
- Relay maximum current – 10A
SKU: EAP-000012
There are no reviews yet.