No products in the cart.
Component, Diode, Electronic Parts
DB104S Bridge Rectifier
Availability:
In stock
DB104S Bridge Rectifier
- Type of bridge rectifier : single-phase
- Maximum Voltage : 400V
- Current : 1A
- Maximum Current : 30A
1,800 Ks
In stock
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module, Relay Module
8 Channel Relay Module (5V,10A)
out of stockDC or AC signal, control, you can control the 220V AC load;
There is a normally open and one normally close contact;
The module is compliant with international safety standards, control and load areas isolation trenches.SKU: EAP-000010 - Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32 Development Board with 1.14 Inch LCD
In StockElectronic Parts, Development Board, ESPRESSIF(ESP)ESP32 Development Board with 1.14 Inch LCD
2 in stock- Wi-Fi Mode Station/SoftAP/SoftAP+Station/P2P
- Security mechanism WPA/WPA2/WPA2-Enterprise/WPS
- Encryption Type AES/RSA/ECC/SHA
- Firmware upgrade UART download/OTA（Through network/host to download and write firmware）
- Software Development Support cloud server development /SDK for user firmware development
- Networking protocol IPv4, IPv6, SSL, TCP/UDP/HTTP/FTP/MQTT
- User Configuration AT + Instruction set, cloud server, android/iOSapp
- OS FreeRTOS
SKU: EAP-000022 - Electronic Parts, Module, OLED Display Module
0.91 OLED Display Module (Blue)
10 in stock- 0.91 inch I2C/IIC 128×32 OLED Display Module
- Work perfectly well without the need of back light.
- 128*32 high resolution, ultra wide viewing angle
- The display is self-illuminating
- Power requirement is low
- Fully compatible with multiple controlling chips including Arduino and more.
- Better performance characteristics than traditional LCD and LED displays.
SKU: EAP-000020 - Electronic Parts, Module, Detection & Sensor Module
HTU21D Temperature and Humidity Sensor Module
In StockElectronic Parts, Module, Detection & Sensor ModuleHTU21D Temperature and Humidity Sensor Module
13 in stock- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002
There are no reviews yet.