No products in the cart.
Motor Speed Controller, Electronic Parts, Module
Motor Speed Controller Voltage Regulator with External Knob(2000W,25A,50-220V AC)
Availability:
In stock
- Input supply voltage: 110V ~ 220V AC
- The output voltage:50V-220V (Output voltage <= Input supply voltage)
- The maximum output power: 2000W
- The maximum output current :25A
- The voltage regulating range:50V-220V AC (Output voltage <= Input supply voltage)
- The operation environment temperature:-20C-40C
5,300 Ks
In stock
This controller uses novel bi-directional high-power SCR. It can be very convenient adjust the current up to 25A, and solve the over current problem of the heating wire resistance is too small in the case of cooling causing good. The output voltage is adjusted anywhere between 50V-220V for use with electrical appliances. It can use to such as electric stove, water heater tune thermal, lighting dimmer, small motor speed, electric iron thermostat, and achieve dimming, thermostats, pressure regulator effect.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module, LCD Display Module
16×2 LCD Display Module + I2C Expander Module
in stock- Arduino IIC/I2C interface was developed to reduce the IO port usage on Arduino board
- I2C adapter allows flexibility in connections
- I2C Reduces the overall wirings
- 16 characters wide, 2 rows
- White text on the green background
- Single LED backlight included can be dimmed easily with a resistor or PWM.
SKU: n/a - Electronic Parts, Module, LCD Display Module
20×4 LCD Display Module + I2C Expander Module
in stock- 2004 204 20X4 Character LCD Display Module Blue Backlight
- Blue & Green backlight
- Fully assembled and tested Serial LCD 20×4 Module
- Display Format: 20 Characters x 4 lines
- Supply voltage: 5V
- The module can be easily interfaced with a MCU
- The module is a low-power consumption character LCD Module with a built-in controller
SKU: n/a - Electronic Parts, Module, Detection & Sensor Module
MFRC-522 RFID Reader Module
37 in stock- RC522 Features
- 13.56MHz RFID module
- Operating voltage: 2.5V to 3.3V
- Communication : SPI, I2C protocol, UART
- Maximum Data Rate: 10Mbps
- Read Range: 5cm
- Current Consumption: 13-26mA
- Power down mode consumption: 10uA (min)
SKU: EAP-000005 - Electronic Parts, Module, Relay Module
4 Channel Relay Module (5V,10A)
out of stock- Useful for appliance control
- DC or AC signal, control, you can control the 220V AC load
- There is a normally open and one normally close contact
- The module is compliant with international safety standards, control and load areas isolation trenches
SKU: EAP-000011
There are no reviews yet.