No products in the cart.
Component, Electronic Parts, Sensors
YS17 Flame sensor smart car (5mm)
Availability:
In stock
- Product name: 5MM F5 Flame Sensor For Smart Car DIY YS-17
- Wavelength : 940nm
- Forward Voltage: 1.2V ~ 1.5V
- Size: 5mm x 9mm
180 Ks
In stock
- Flame thermal radiation has the discrete spectrum of gas radiation and continuous spectrum of solid radiation,
- YS – 17 flame using infrared sensor on the characteristics of the flame is very sensitive, use special infrared
- receiving tube to detect flame thermal radiation, and then the flame brightness changes into high and low level
- signal, again through the comparator compared with reference voltage threshold, reaches the threshold voltage, output low level modules.
- YS – 17 flame sensor, for all kinds of fire, fire detection. Can detect the flame or wavelength at 760 nm to 760 nm range of light source,
- the greater the flame, test the farther the distance detection Angle is about 60 degrees, particularly sensitive to the flame spectrum,
- module testing sensitivity can be adjusted through the potentiometer.
- Product name: 5MM F5 Flame Sensor For Smart Car DIY YS-17
- Wavelength : 940nm
- Forward Voltage: 1.2V ~ 1.5V
- Size: 5mm x 9mm
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
11 in stock- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013 - Electronic Parts, Module, Relay Module
2 Channel Relay Module (5V,10A)
6 in stock- Switching mains loads
- Home automation
- Battery backup
- High current load switching
- Supply voltage – 3.75V to 6V
- Trigger current – 5mA
- Current when relay is active – ~70mA (single), ~140mA (both)
- Relay maximum contact voltage – 250VAC, 30VDC
- Relay maximum current – 10A
SKU: EAP-000012 - Electronic Parts, Development Board, Raspberry Pi
Raspberry Pi Pico RP2040 Programming Development Board
In StockElectronic Parts, Development Board, Raspberry PiRaspberry Pi Pico RP2040 Programming Development Board
3 in stock- RP2040 microcontroller chip designed by Raspberry Pi
- 264KB of SRAM, and 2MB of onboard Flash memory
- The castellated module allows soldering directly to carrier boards
- Dual-core Arm Cortex M0+ processor, the flexible clock running up to 133 MHz
- Drag-and-drop programming using mass storage over USB
- 26 × multi-function GPIO pins
- 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
- USB 1.1 with device and host support
- Low-power sleep and dormant modes
- Accurate clock and timer on-chip
- Onboard temperature sensor
- Accelerated floating-point libraries on-chip
- 8 × Programmable I/O (PIO) state machines for custom peripheral support
SKU: EAP-000607 - Electronic Parts, Module, OLED Display Module
TM1637 Clock Display Module
13 in stock- Ease to use.
- Ease of multiplexing.
- Can use as a 4 digit display unit.
- Can use as a clock display.
- DIY clock project.
- 4 digit display unit.
- Electrical/Electronic projects.
- The counter project using 7 segment display.
- 4 M2 screws positioning holes for easy installation
SKU: EAP-000007
There are no reviews yet.