No products in the cart.
Resistor Network (A102J), 1kΩ
Resistor Network (A103J), 10kΩ
Resistor Network (A10J151), 150Ω
| Part No | A102J,1kΩ, A103J,10kΩ, A151J, 150Ω |
|---|
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, LCD Display Module, Module
20×4 LCD Display Module + I2C Expander Module
- 2004 204 20X4 Character LCD Display Module Blue Backlight
- Blue & Green backlight
- Fully assembled and tested Serial LCD 20×4 Module
- Display Format: 20 Characters x 4 lines
- Supply voltage: 5V
- The module can be easily interfaced with a MCU
- The module is a low-power consumption character LCD Module with a built-in controller
SKU: n/a - DIY Items, Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
18 in stock- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013 - Development Board, Electronic Parts, Raspberry Pi
Raspberry Pi Pico RP2040 Programming Development Board
Stock outDevelopment Board, Electronic Parts, Raspberry PiRaspberry Pi Pico RP2040 Programming Development Board
Out of stock- RP2040 microcontroller chip designed by Raspberry Pi
- 264KB of SRAM, and 2MB of onboard Flash memory
- The castellated module allows soldering directly to carrier boards
- Dual-core Arm Cortex M0+ processor, the flexible clock running up to 133 MHz
- Drag-and-drop programming using mass storage over USB
- 26 × multi-function GPIO pins
- 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels
- USB 1.1 with device and host support
- Low-power sleep and dormant modes
- Accurate clock and timer on-chip
- Onboard temperature sensor
- Accelerated floating-point libraries on-chip
- 8 × Programmable I/O (PIO) state machines for custom peripheral support
SKU: EAP-000607 - Electronic Parts, LCD Display Module, Module
20×4 Character LCD Display Module (Blue)
17 in stock- LCD display module with blue backlight
- It can display 4-lines * 20-characters
- Small and light appearance, it is easy and convenient to use
- Suitbale for copiers, fax machines, laser printers, industrial test equipment, networking equipment etc
SKU: EAP-000016
There are no reviews yet.