No products in the cart.
All Products
Showing 1–36 of 883 results
- Electrical, Electrical & Mechanical, Industrial Equipment & Materials, Industrial Materials, Solder Wire
0.8mm Solder Wire High Quality ( Small size )
DiscontinuedStock outElectrical, Electrical & Mechanical, Industrial Equipment & Materials, Industrial Materials, Solder Wire0.8mm Solder Wire High Quality ( Small size )
Out of stock- 63/37 rosin core solder
- FLUX 2.0%
- Wire diameter: 0.8mm
- Melting point: 361°F/183°C
- Good solderability, insulation resistance, No spattering and Non-corrosive
- Widely used in electrical and electronics, solder parts like circuit board, electronics devices and others
SKU: EAP-000874 - Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A, HIGH ACTIVE)
222 in stock- 1-channel 5V control Single-Pole Double-Throw (SPDT) AC power relay board can be controlled directly via a microcontroller and switch up to 10 amperes at 250 VAC
- Inputs are isolated to protect any delicate control circuitry
- The default state of the relay when the power is off for COMM (power) to be connected to NC (Normally Closed). This is the equivalent of setting the relay board IN pin to HIGH (has +5v sent to it)
- Relay Max Switching Voltage: 250 Volts AC; Relay Max Switching: Current: 10 Amps AC; Relay Control Voltage: 5.0V directly via microcontroller (Arduino, AVR, PIC, ARM, Board X, Raspberry Pi, MSP430, etc)
SKU: EAP-001176 - Battery Holder, Component, DIY Items, Electronic Parts, Trending Items
18650 Battery Holder Case
In StockBattery Holder, Component, DIY Items, Electronic Parts, Trending Items18650 Battery Holder Case
- Material: ABS plastic
- Type: For 18650 Battery
- Input Voltage: 3.7V
- Color: Black
- Design: With output cables, black for —, red for +
- Slot(s):1/2/3/4 (Series & Parallel)
- Cable Length:13.5cm
- Case Height:2cm
- Case Length:7.6cm
SKU: n/a - DIY Items, Electronic Parts, Module, Trending Items
18650 DIY Spot Welder (12V)
8 in stock- Material: PCB
- Suitable for: 18650/26650/32650 lipo battery
- System voltage: 12-V-14.6V
- Working current: 90-150A
- It is recommended to install the product by the people who have basic electrical knowledge and hands-on ability.
SKU: EAP-001247 - DIY Items, Electronic Parts, Module, Trending Items
18650 Li-ion 1S BMS Module (3A)
4528 in stock- High-accuracy voltage detection circuit;
- Terminal of the charger using high voltage device;
- Built-in three-stage over-current detection circuit (over-current 1, over-current 2, load short circuit);
- MOS transistor can control the battery charge and discharge;
SKU: EAP-001226 - Electrical, Electrical & Mechanical, Mechanical, Motor, Wheels & Pulleys
2WD Smart Car Chassis Kit (Acrylic Frame)
In StockElectrical, Electrical & Mechanical, Mechanical, Motor, Wheels & Pulleys2WD Smart Car Chassis Kit (Acrylic Frame)
1 in stock- Round Plate Diameter: 135 mm
- Square Plate Size:135×90 mm
- Wheel Size (D x W) mm: 65 x 25
- Motor Type: Dual shaft-Straight, BO motor
- Motor Operating Voltage: 3 to 6V DC
- Motor Rated RPM: No Load Speed (3V) 90RPM +-10%
- Motor Gear reduction Ratio: 1:48
- Motor Rated Current: No Load Current (3V) Less Than 150mA
- Chassis Material & Color: Acrylic Transparent
- Wheel Material: Plastic with Rubber
SKU: EAP-000665
