No products in the cart.
Component, Electronic Parts, Switch, Button & Connector
DC Power Jack (5.5mm)
Availability:
In stock
- Model Number :DC jack
- Type : ADAPTER, DC JACK
- Application :Power
- Product name :DC Power jack
- Rated load :DC30V 0.5A
- Contact Résistance:≤0.3Ω
- Insulation Voltage:≥100m Ω
- Working temperature:-40~75°
100 Ks
In stock
- Application to Media Player, MP3 Player, MP4 Player, Audio-Video Equipment, AV Equipment, Note Book, Cellular Phone, Mobile Phone, Cell Phone, Smart Phone, PDA, Car Audio etc.
- Terminals are also solder able; 5000 cycles of insertion and extraction.
- 3 pins, right angle, PCB mounting.
- Model Number :DC jack
- Type : ADAPTER, DC JACK
- Application :Power
- Product name :DC Power jack
- Rated load :DC30V 0.5A
- Contact Résistance:≤0.3Ω
- Insulation Voltage:≥100m Ω
- Working temperature:-40~75°C
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module, Detection & Sensor Module
MFRC-522 RFID Reader Module
7 in stock- RC522 Features
- 13.56MHz RFID module
- Operating voltage: 2.5V to 3.3V
- Communication : SPI, I2C protocol, UART
- Maximum Data Rate: 10Mbps
- Read Range: 5cm
- Current Consumption: 13-26mA
- Power down mode consumption: 10uA (min)
SKU: EAP-000005 - Electronic Parts, Module, Detection & Sensor Module
HTU21D Temperature and Humidity Sensor Module
In StockElectronic Parts, Module, Detection & Sensor ModuleHTU21D Temperature and Humidity Sensor Module
7 in stock- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 - Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32-Cam Development Board
5 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - Electronic Parts, Module, Detection & Sensor Module
Raindrop Detection Sensor Module
12 in stock- The LM393, use of the wide voltage comparator
- Provide both digital and analog output
- Output LED indicator
- Compatible with Arduino
- TTL Compatible
- The sensor uses the high-quality FR – 04 double material, the large area of 5.5*4.0 CM
- Treatment of nickel plating and surface, have fight oxidation, electrical conductivity, and life has more superior performance
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15mA
- With potentiometer sensitivity adjustment
- The output format: digital switch output (0 and 1) and analog AO voltage output;
- Has a fixed bolt hole, convenient installation
SKU: EAP-000001
There are no reviews yet.