No products in the cart.
Module
Showing 73–108 of 239 results
- Electronic Parts, Module
MAX7219 Dot Matrix LED Display Module (1×8)
3 in stock- Requires only 3 communication wires of MCU
- Pre-cascaded MAX7219 Dot Matrix LED Module.
- The overall size of the display is very compact
- The PCB features M3 holes for mounting.
- Module with input and output interfaces
- Support for cascading multiple modules
- Quite large display
- Work Temperature:-25℃~85℃
- Work Humidity:5%~95%RH
- Input Voltage: 3.7 to 5.3 V
SKU: EAP-000127 - Electronic Parts, Module
MAX7219 Dot Matrix LED Display Module (2×8)
1 in stock- Requires only 3 communication wires of MCU
- Pre-cascaded MAX7219 Dot Matrix LED Module.
- The overall size of the display is very compact
- The PCB features M3 holes for mounting.
- Module with input and output interfaces
- Support for cascading multiple modules
- Quite large display
- Work Temperature:-25℃~85℃
- Work Humidity:5%~95%RH
- Input Voltage: 3.7 to 5.3 V
SKU: EAP-000128 - Electronic Parts, LCD Display Module, Module
MCP23017 16-bit I2C Port Expander Module
8 in stockThe MCP23017 16-bit I2C Port Expander Module expands the GPIO capability of your microcontroller by adding 16 programmable digital input/output pins through the I2C interface. The module is widely used to control HD44780 Character LCDs (16×2, 20×4), 128×64 Graphic LCDs (Parallel Interface). It is ideal for Arduino, ESP32, STM32, Raspberry Pi, and other embedded systems where additional GPIO pins are required. The module supports configurable pull-up resistors, interrupt outputs, and adjustable I2C addresses for connecting multiple devices on the same bus.
SKU: EAP-001398 - Component, Detection & Sensor Module, Electrical, Electrical & Mechanical, Electronic Parts, Module, Sensors, Sensors
MD-PS002 Pressure Sensor
In StockComponent, Detection & Sensor Module, Electrical, Electrical & Mechanical, Electronic Parts, Module, Sensors, SensorsMD-PS002 Pressure Sensor
1 in stock-   The chip surface coating protection against water vapor, dust and other chip;
-   Pressure connection stainless steel, pressure;
-   Pin-defined, easy connection;
-   A variety of range to choose from.
- Â Size6.8*6.8*4.6mm
-  Zero output  ± 8 mV / v /  ± 10 mV / v
-   Full scale output 65-115 mV / 75-125 mV / 170-280 mV
-   Linearity of ± 0.20% FSO / ± 0.25% FSO
-   Hysteresis and repeatability of ± 0.10% FSO
-   Zero temperature coefficient of ± 30 μv / v / ° C
-   Resistance temperature coefficient of 0.30% / ° C
-   Sensitivity temperature coefficient of -0.20% FSO /  ° C
-   Zero Thermal Hysteresis ± 0.10% FSO
-   Long-term stability of ± 0.20% FSO
SKU: EAP-000732 - Battery Charging Module, DIY Items, Electronic Parts, Module, Trending Items
MH-KC24 QC3.0 QC2.0 Fast Charging Module
In StockBattery Charging Module, DIY Items, Electronic Parts, Module, Trending ItemsMH-KC24 QC3.0 QC2.0 Fast Charging Module
352 in stock- Supports multiple fast charging protocols.
- Input over-voltage, over current, and under-voltage protection.
- Output overcurrent, short circuit protection
- Module over-temperature protection.
- Used to charge solar mobile phone, car charging retrofit, driving recorder power supply, home power conversion, etc.
SKU: EAP-001230 - Battery Charging Module, Electronic Parts, Module, Power Bank Module
MH-KC24 QC3.0 QC2.0 Fast Charging Module (2 Channel)
In StockBattery Charging Module, Electronic Parts, Module, Power Bank ModuleMH-KC24 QC3.0 QC2.0 Fast Charging Module (2 Channel)
13 in stockThe MH-KC24 QC3.0 QC2.0 Fast Charging Module (2 Channel) is a highly efficient DC-DC buck converter designed to provide fast USB charging for mobile devices, supporting multiple fast charging protocols. This module accepts a wide input voltage range and features two independent USB ports for simultaneous charging.
SKU: EAP-001340 - Battery Charging Module, Electronic Parts, Module, Power Bank Module
MH-KC24 QC3.0 QC2.0 Fast Charging Module (4 Channel)
In StockBattery Charging Module, Electronic Parts, Module, Power Bank ModuleMH-KC24 QC3.0 QC2.0 Fast Charging Module (4 Channel)
22 in stockThe MH-KC24 QC3.0 QC2.0 Fast Charging Module (4 Channel) is a DC-DC buck converter board with four independent USB ports that automatically adjusts the output voltage to provide fast charging to compatible devices. This module can deliver up to 24W of power per channel from a single power input.
SKU: EAP-001341 - Electronic Parts, Module
Mini MFRC-522 RFID Reader Module
29 in stock- Working current: 13～26mA
- Working voltage: 3.3V
- Working temperature: -20℃～80℃
- Operating frequency: 13.56MHz
- Sleep current: <80uAÂ
- Peak current: <30mAÂ
- Working frequency: 13.56MHzÂ
- Supported card types: mifare1 S50, mifare1 S70, mifare UltraLight, mifare Pro, mifare Desfire
SKU: EAP-001136 - Battery Charging Module, DIY Items, Electronic Parts, Module, Power Bank Module, Trending Items
Mini Power Bank Module (2A, Type C)
Stock outBattery Charging Module, DIY Items, Electronic Parts, Module, Power Bank Module, Trending ItemsMini Power Bank Module (2A, Type C)
Out of stock- Input Voltage: 5V DC via Type-C port.
- Output Voltage: 5V DC at 2A max.
- Battery Type: Compatible with 3.7V lithium-ion batteries.
- Charging Current: 1A to 2A, adjustable.
- Protection Features: Overcharge, over-discharge, and short-circuit protection.
SKU: EAP-001307 - Battery Charging Module, Electronic Parts, Module, Power Bank Module
Mini Power Bank Module (2A, Type C)
Stock outBattery Charging Module, Electronic Parts, Module, Power Bank ModuleMini Power Bank Module (2A, Type C)
Out of stock- Output Current: 5V/2.4A
- Charging Voltage: DC 4.5V-5.5V (Recommended to use 5V)
- Charging Current: 0-2.1A
- Output Voltage: 5V ±2%
- Efficiency: >96%
- Standby Current: 80uA
- Operating Temperature: -20℃ ~ +85℃
SKU: EAP-001308 - Electronic Parts, Module
Mini RS232 to TTL MAX3232 Converter Module Board
200 in stock- Chip Model :Â MAX232CSE.
- Protocol :Â RS232
- Operating Voltage (VDC) :Â 3 ~ 5
- Max. Baud Rate :Â No more than 120kbps.
- Operation :Â Full Duplex
- Receiver Hysteresis :Â 300mV.
- Transceiver :Â 2 (1 TTL -> RS232 + 1 TTL <- RS232)
- Operating Tempreture :Â -40C ~ 85C
SKU: EAP-000909 - DIY Items, Electronic Parts, Module, Motor Speed Controller, Trending Items
Motor Speed Controller Voltage Regulator with External Knob(2000W,25A,50-220V AC)
In StockDIY Items, Electronic Parts, Module, Motor Speed Controller, Trending ItemsMotor Speed Controller Voltage Regulator with External Knob(2000W,25A,50-220V AC)
32 in stock- Input supply voltage: 110V ~ 220V AC
- The output voltage:50V-220V (Output voltage <= Input supply voltage)
- The maximum output power: 2000W
- The maximum output current :25A
- The voltage regulating range:50V-220V AC (Output voltage <= Input supply voltage)
- The operation environment temperature:-20C-40C
SKU: EAP-000653 - Electronic Parts, Module
NE555 Adjustable Signal Generator Module
30 in stock- NE555 chip onboard
- A single channel output, the output duty cycle square wave is about fifty percent
- Onboard adjustable resistance, resistance can be controlled to adjust the output frequency
- Working voltage: 5 – 12V
- Board size: 29 (mm) x12 (mm)
SKU: EAP-000878 - Electronic Parts, GPS Module, Module
NEO 6M GPS Module with External Antenna
97 in stock- 5Hz position update rate
- Operating temperature range: -40 TO 85°CUART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Supply voltage: 3.3 V
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
SKU: EAP-001189 - Electronic Parts, Module, Trending Items
NRF 24L01 Adapter Module
Out of stock- Model: YL-105
- Input Voltage: 5V
- Output Voltage: 3.3V
- Compatible Module: NRF24L01 / NRF24L01+
- Operating Frequency: 2.4GHz ISM Band (depends on NRF24L01 module)
- Applications: Arduino UNO, Nano, Mega, STM32, ESP32, and other development boards
SKU: EAP-001396 - Electronic Parts, Module, Wireless Module
NRF24L01 Wireless Module
34 in stock- 2.4GHz RF transceiver Module
- Operating Voltage: 3.3V
- Nominal current: 50mA
- Range : 50 – 200 feet
- Operating current: 250mA (maximum)
- Communication Protocol: SPI
- Baud Rate: 250 kbps – 2 Mbps
- Channel Range: 125
- Maximum Pipelines/node : 6
- Low cost wireless solution
SKU: EAP-000511 - Electronic Parts, Module, Wireless Module
NRF24L01+PA+LNA Long Distance Wireless Module with Antenna (1.1 km, 2.4GHz)
Stock outElectronic Parts, Module, Wireless ModuleNRF24L01+PA+LNA Long Distance Wireless Module with Antenna (1.1 km, 2.4GHz)
Out of stockNRF24L01+PA+LNA Wireless Module 1100 Meters
- Operating Frequency: 2400MHz ~ 2524MHz
- Modulation: GMSK
- Transmit power: more than +20 dbm, 50Ω
- Receiver sensitivity:-95dbm
- Operating voltage: 2.7V ~ 3.6V
- Max Emission current: 115mA
- Max Receive current: 45mA
- Operating temperature: -45 degrees to +85 degrees
- Storage temperature: -45 degrees to +125 degrees
- Gain Of PA: 20 dB
- Gain Of LNA: 10 dB
SKU: EAP-000510 - Electronic Parts, Module
OV7670 Camera Module
Out of stockThe OV7670 Camera Module is a compact, low-cost CMOS image sensor designed for embedded vision and image capture applications. It features the OV7670 VGA camera sensor, capable of capturing images at a maximum resolution of 640 × 480 (VGA). The module communicates through an 8-bit parallel data interface and is configured via the SCCB (I²C-compatible) interface, making it suitable for Arduino, STM32, ESP32 (with parallel camera support), FPGA, and other microcontroller development platforms.This module is widely used in DIY electronics, machine vision, robotics, image processing, and computer vision projects where an affordable camera solution is required.
SKU: EAP-001409 - Electronic Parts, Module
PA-465 PIR Motion Sensor (9~16V)
Out of stock- @Sensor : Bilateral square, low noise, high sensitivity
- Signal Processing : automatic temperature control
- Exploration speed : 0.2m-7m/sec
- Working Temperature : – 10°C-+50°C
- Electrical power input : DC9-16V, max. 18mA
- Transparent Mirror : LODIFF transparent mirror
- Defense Development : DC28V0.15A
- Dimension : 108mm(Length)x35mm(Height)
SKU: EAP-001148 - Electronic Parts, Module
PN532 RFID Module (Read/Write)
18 in stock- Communication distance: 5cm~7cm
- Support protocols like II2, SPI and HSU (High-Speed UART)
- I2C / UART TTL Voltage level –Â 3.3V ~ 24V TTL
- On-board level shifter available that reduces external components.
- Work in NFC Mode
- Work in RFID reader/writer Mode
- Does not require external Antenna due to Built-in PCB Antenna supports communication over 4cm~6cm.
- Work as a 1443-A card or a virtual card
SKU: EAP-001137 - Battery Charging Module, DIY Items, Electronic Parts, Module, Power Supply Module, Trending Items
Power Bank Module with Temperature Circuit Protection (5V 4.5A 22.5W, QC3.0 QC4.0, Dual USB Output, Micro and Type-C Input)
Stock outBattery Charging Module, DIY Items, Electronic Parts, Module, Power Supply Module, Trending ItemsPower Bank Module with Temperature Circuit Protection (5V 4.5A 22.5W, QC3.0 QC4.0, Dual USB Output, Micro and Type-C Input)
Out of stock- Package:Â QC4.0+PD3.0
- Model Number:Â 5V 4.5A 22.5W Mobile Power Bank
- Operating Temperature:Â 18650 Charging Module
- Dissipation Power:Â 22.5W Power bank
- Supply Voltage:Â Circuit Protection
- Type:Â Voltage Regulator
- Type-C USB Mobile Power Bank
- Size: 72*27*6mm (L*W*H)
SKU: EAP-001024 - Detection & Sensor Module, Electronic Parts, Module, Trending Items
Pulse Heart Rate Sensor Module
Stock outDetection & Sensor Module, Electronic Parts, Module, Trending ItemsPulse Heart Rate Sensor Module
Out of stockThe Pulse Heart Rate Sensor Module is an optical pulse sensor designed to measure heart rate by detecting blood flow changes through a fingertip or earlobe. It provides an analog output signal that can be easily interfaced with Arduino, ESP32, Raspberry Pi, and other microcontroller platforms.
SKU: EAP-001399
