No products in the cart.
Electronic Parts
Showing 577–612 of 628 results
- Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32 Development Board
Out of stock- Built in Wi-Fi module of standard 802.11
- Wi-Fi module operate in range of 2.4 GHz – 2.5 GHz
- Three modes of operation: 1. Access point. 2. Client. 3. Access point + station
- Dual core microprocessor of 32 – bit
- Operating voltage is 3.3 V
- Clock frequency from 80 MHz and goes up to 240 MHz
- SRAM memory is of 512 KB
- ROM memory is 448 KB
- External flash memory is supported and is up to 32 Mb i.e. 4MB
- Maximum current in each pin is 12 mA but 6 mA is recommended to use
- It has 36 general purpose input / output pins
- General purpose input / output pins comes up with PWM / I2C and SPI functionality
- Bluetooth version 4.2 is available and Bluetooth low energy (BLE) version
- 2 to 3.6 V operating voltage
- Deep sleep current of 2.5 µA
- 10 electrode capacitive touch support
- Hardware supported encryption for AES, ECC, RSA – 4096, SHA2
- On board PCB antenna or IPEX connector which act as external antenna
- Operating temperature lies in range of -40°C to +125°C
SKU: EAP-000025 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32 Development Board with 1.14 Inch LCD
Stock outDevelopment Board, Electronic Parts, ESPRESSIF(ESP)ESP32 Development Board with 1.14 Inch LCD
Out of stock- Wi-Fi Mode Station/SoftAP/SoftAP+Station/P2P
- Security mechanism WPA/WPA2/WPA2-Enterprise/WPS
- Encryption Type AES/RSA/ECC/SHA
- Firmware upgrade UART download/OTA（Through network/host to download and write firmware）
- Software Development Support cloud server development /SDK for user firmware development
- Networking protocol IPv4, IPv6, SSL, TCP/UDP/HTTP/FTP/MQTT
- User Configuration AT + Instruction set, cloud server, android/iOSapp
- OS FreeRTOS
SKU: EAP-000022 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32 Development Board with SIM800L V1.3
DiscontinuedStock outDevelopment Board, Electronic Parts, ESPRESSIF(ESP)ESP32 Development Board with SIM800L V1.3
Out of stock- Wi-Fi mode: Station/SoftAP/SoftAP+Station/P2P
- Security mechanism: WPA/WPA2/WPA2-Enterprise/WPS
- Encryption type: AES/RSA/ECC/SHA
- Firmware upgrade: UART download/OTA（Through network/host to download and write firmware）
- Software development: Support cloud server development /SDK for user firmware development
- Networking protocol: IPv4、IPv6、SSL、TCP/UDP/HTTP/FTP/MQTT
- User configuration: AT + Instruction set, cloud server, android/iOSapp
- OS: FreeRTOS
SKU: EAP-000023 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP32-Cam Development Board
30 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 - Development Board, Electronic Parts, ESPRESSIF(ESP)
ESP8266 Development Board (CP2102)
47 in stock- Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
- Arduino-like hardware IO
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- Onboard USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
- Has onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
- Easy access to the GPIO pins for easy prototyping
- ESP-12E Processor
- Easy to use breadboard friendly form factor
SKU: EAP-000026 - Detection & Sensor Module, Electronic Parts, Module
GY-906 MLX90614 Non-Contact Precision Infrared Temperature Sensor Module
In StockDetection & Sensor Module, Electronic Parts, ModuleGY-906 MLX90614 Non-Contact Precision Infrared Temperature Sensor Module
19 in stock- Easy to integrate
- Mounted on a breakout board with two types of pins
- 10k Pull up resistors for the I2C interface with optional solder jumpers
- Factory calibrated in temperature range:
- -40+125°C for sensor temperature
- -70+380°C for object temperature
- High accuracy of 0.5°C over wide temperature range (+50°C for both) High (medical) accuracy calibration
- Measurement resolution of 0.02°C
- Single and dual zone versions
- SMBus compatible digital interface
- Customizable PWM output for continuous reading
SKU: EAP-000122 - Detection & Sensor Module, Electronic Parts, Module
HTU21D Temperature and Humidity Sensor Module
Stock outDetection & Sensor Module, Electronic Parts, ModuleHTU21D Temperature and Humidity Sensor Module
Out of stock- Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 - Electronic Parts, Module
I2C Expander Module
27 in stock- Operating Voltage: 5V
- Backlight and Contrast is adjusted by potentiometer
- Serial I2C control of LCD display using PCF8574
- Come with 2 IIC interface, which can be connected by Dupont Line or IIC dedicated cable
- This is another great IIC/I2C/TWI/SPI Serial Interface
- With this I2C interface module, you will be able to realize data display via only 2 wires.
SKU: EAP-000114 - Electronic Parts, Module
IR Optocoupler Module
7 in stock- Use imported groove coupler sensor
- groove width 5 mm.
- The indicator lamp is off, the output is high, the output is low.
- Obscured, high output; unobstructed, low output
- Clean signal comparator output, good waveform, more than 15mA driving capability.
- Voltage 3.3 V – 5 V
- Output format: digital switching output (0 and 1)
- Fixed bolt holes for easy installation
SKU: EAP-000104 - Electronic Parts, Module
IR Receiver Module
112 in stock- Can detect a flame or in a 760 nanometer wavelength of ~ 1100 nm range of the light, lighter flame test distance of 80cm, for the greater flame, the farther the distance test
- The detection angle of 60 degrees or so, particularly sensitive to the flame spectrum
- Sensitivity adjustable (shown in blue digital potentiometer adjustment)
- the comparator output signal clean, good waveform, driving ability, more than 15mA
- With adjustable precision potentiometer sensitivity adjustment
- The working voltage of 3.3V-5V
- The output format: DO digital switching outputs (0 and 1) and AO analog voltage output
- A fixed bolt holes for easy installation
SKU: EAP-000108 - Electronic Parts, Module, Motor Driver Module
IRF520 MOSFET Driver Module
6 in stock- Voltage: 3.3 – 5V.
- Ports: Digital Level.
- Output load voltage: 0-24 V.
- Output load current: <5A (1A above need to add heat sink).
- Platform: Arduino, MCU, ARM, raspberry pi.
- Using original IRF520 Power MOS, you can adjust the output PWM
SKU: EAP-000120 - Electronic Parts, Module
MAX7219 Dot Matrix LED Display Module (1×1)
19 in stock- Requires only 3 communication wires of MCU
- Pre-cascaded MAX7219 Dot Matrix LED Module.
- The overall size of the display is very compact
- The PCB features M3 holes for mounting.
- Module with input and output interfaces
- Support for cascading multiple modules
- Quite large display
- Work Temperature:-25℃~85℃
- Work Humidity:5%~95%RH
- Input Voltage: 3.7 to 5.3 V
SKU: EAP-000124 - Electronic Parts, Module
MAX7219 Dot Matrix LED Display Module (1×4)
Out of stock- Requires only 3 communication wires of MCU
- Pre-cascaded MAX7219 Dot Matrix LED Module.
- The overall size of the display is very compact
- The PCB features M3 holes for mounting.
- Module with input and output interfaces
- Support for cascading multiple modules
- Quite large display
- Work Temperature:-25℃~85℃
- Work Humidity:5%~95%RH
- Input Voltage: 3.7 to 5.3 V
SKU: EAP-000125 - Electronic Parts, Module
MAX7219 Dot Matrix LED Display Module (2×2)
Out of stock- Requires only 3 communication wires of MCU
- Pre-cascaded MAX7219 Dot Matrix LED Module.
- The overall size of the display is very compact
- The PCB features M3 holes for mounting.
- Module with input and output interfaces
- Support for cascading multiple modules
- Quite large display
- Work Temperature:-25℃~85℃
- Work Humidity:5%~95%RH
- Input Voltage: 3.7 to 5.3 V
SKU: EAP-000126 - Detection & Sensor Module, Electronic Parts, Module
MFRC-522 RFID Reader Module
109 in stock- RC522 Features
- 13.56MHz RFID module
- Operating voltage: 2.5V to 3.3V
- Communication : SPI, I2C protocol, UART
- Maximum Data Rate: 10Mbps
- Read Range: 5cm
- Current Consumption: 13-26mA
- Power down mode consumption: 10uA (min)
SKU: EAP-000005 - Electronic Parts, Module, Motor Driver Module
PWM MOSFET Driver Module (15A, 400W)
Out of stock- Operating Voltage (VDC): 5 ~ 36V
- Peak Current (A): 30A
- Continuous Current (A) : 15A
- No. of Channels: 1
- Battery Protection Mode: No
- Operating temperature: -40 ~ +85
- Cooling Fan: No
- Arduino Shield: No- can be used with Wire connection
- Speed Control: Yes
- Polarity Protection: NO
SKU: EAP-000130 - Detection & Sensor Module, Electronic Parts, Module
Raindrop Detection Sensor Module
423 in stock- The LM393, use of the wide voltage comparator
- Provide both digital and analog output
- Output LED indicator
- Compatible with Arduino
- TTL Compatible
- The sensor uses the high-quality FR – 04 double material, the large area of 5.5*4.0 CM
- Treatment of nickel plating and surface, have fight oxidation, electrical conductivity, and life has more superior performance
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15mA
- With potentiometer sensitivity adjustment
- The output format: digital switch output (0 and 1) and analog AO voltage output;
- Has a fixed bolt hole, convenient installation
SKU: EAP-000001 - Component, Diode, Electronic Parts
Rectifier Diode x 10Pcs
- A rectifier is an electrical device used to convert alternating current (AC) into direct current (DC) by allowing a current to flow through the device in one direction only.
- Diodes work like one-way valves within the rectifier to maintain this flow of current.
SKU: n/a - Electrical & Mechanical, Electronic Parts, Motor, Trending Items
SG90 Micro Servo Motor
The TowerPro SG90 servo motor is one of the most popular servo motors at the moment. This servo motor has a torque of up to 1.56 kg * cm, with which all kinds of sensors, cameras or even small robots can easily be moved.
SKU: n/a - Electronic Parts, Module, Wireless Module
SIM900A GSM Module
2 in stock- Dual-Band 900/ 1800 MHz
- GPRS multi-slot class 10/8GPRS mobile station class B
- Compliant to GSM phase 2/2+
- Dimensions: 24*24*3 mm
- Weight: 3.4g
- Control via AT commands (GSM 07.07 ,07.05 and SIMCOM enhanced AT Commands)
- Supply voltage range : 5V
- Low power consumption: 1.5mA (sleep mode)
- Operation temperature: -40°C to +85 °
SKU: EAP-000106 - Electronic Parts, Module
SMD Soldering Training Board
9 in stock- After welding, just connect electricity (3-12V) to see the effect. You can quickly judge the welding effect. The welding product is a beautiful water lamp circuit.
- The back of the board with mm/Inch ruler, Easy to measure component
- It’s DIY Kits, Blue Led. This is a perfect Soldering skills training materials for beginners
- High quality PCB, has clearly marked the electronics components, even beginners can easily solder successfully.
SKU: EAP-000133 - Detection & Sensor Module, Electronic Parts, Module
Soil Moisture Sensor Module
224 in stock- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
- Operating Voltage: 3.3V~5V
SKU: EAP-000103 - Detection & Sensor Module, Electronic Parts, Module
Sound Detection Sensor Module
117 in stock- Material : plastic
- Size: approx. 32mm*17mm*15mm(length*width*height)
- Main Chip: LM393, Electret condenser microphone
- Working Voltage: DC 4-6V
- Color: Blue
- Note: The Maximum induction distance is 0.5M
SKU: EAP-000102
